Product name:Beecore F4 with buil-in OSD and 10A ESC
Product code:HSM-FT107
BeeCore F4 flight control 1-2S integrated four-in-one brushless ESC, using MPU6000 sensor and connected via SPI bus to improve the sampling rate of the sensor, F4 master to improve the operating frequency of the program, providing higher control accuracy and faster responding speed. The integrated OSD comes with Betaflight online tuning, which is used in the current horizon four-axis small brushless four-axis rack. Integrated 4-in-1 ESC supports DSHOT signal output. Light weight, small size, low thickness and so on.
For receiver configuration, SBUS/IBUS and DSM receiver inputs, configure RX2 as the input interface.
Flight control configuration:
CPU: STM32F411CEU6
Sensor: MPU-6000 three-axis accelerometer / three-axis gyroscope (SPI connection)
Power supply: 1-2S battery input (DC 3.2V-8.4V)
BEC: Built-in buck-boost circuit (1S input BEC output 0.5A, 2S input BEC output 1.5A)
Receiver: PPM, SBUS, IBUS, Spektrum DSM2/DSMX, 1024/2048.
Built-in OSD interface
Support BLheli suite ESC programming
Support DHSOT ESC
Built-in voltage detection
Board size: 28.5*28.5MM
Screw hole spacing: 24.5*24.5MM diameter 3.0MM
Board weight: 3.2 grams
Brushless ESC configuration:
Power supply: 1-2S
Current : 10A continuous peak 12A (for 2 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.HEX
Signal support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM
