Description
SDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDPrice:$15.99
Product name:LED Kit with controller for Quadcopter
Product code:HSM-161A
Specifications:
Working voltage:12V(connect directly to your 3S Lipo charging port.
LED Strip:4pcs Waterproof,blue,red,green and white,20cm for each(need to solder to JST connector)
4Pcs of JST Male connector with 10cm 26AWG cable for solder the 4pcs of LED strip
Control mode：Auto-mode and Manual mode
Flashing Mode:Constant on,Flashing one by one,Flashing double by double and LED OFF.
During auto-mode,the LED will always keep constant on and you can't control it;
In Manual mode,you can control the LED by your transmitter,to use this funciton,it needs to set an auxiliary channel on your transmitter，you can turn on and turn off the LED from your TX,also you can switch the flashing modes.
Attention:This is for 3S Battery only,please don't connect it to the rc power source higher than 12.0 voltage,like 4S Lipo,otherwise,it will cause damage to the controller.When solder the LED strip,please pay attention to the positive and negative of the JST connector,otherwise,it will cause damage to the LED.
